AEG BSE782320M Manuel d'utilisateur télécharger pdf (Page 50)

Problem Possible cause Remedy

The display shows an error

code that is not in this table.

There is an electrical fault. • Turn off the oven with the

house fuse or the safety

switch in the fuse box

and turn it on again.

• If the display shows the

error code again, contact

the Customer Care De-

partment.

Steam and condensation

settle on the food and in the

cavity of the oven.

You left the dish in the oven

for too long.

Do not leave the dishes in

the oven for longer than 15 -

20 minutes after the cooking

process ends.

The appliance is activated

and does not heat up. The

fan does not operate. The

display shows "Demo".

The demo mode is activa-

ted.

Refer to "Basic Settings" in

"Daily use" chapter.

The descaling procedure is

interrupted before it finishes.

There was a power cut. Repeat the procedure.

The descaling procedure is

interrupted before it finishes.

The function was stopped by

the user.

Repeat the procedure.

There is no water inside the

grill- / roasting pan after the

descaling procedure.

You did not fill the water

drawer to the maximum lev-

el.

Check if the a descaling

agent / water is present in

the water drawer body.

Repeat the procedure.

There is dirty water on the

bottom of the cavity after

the descaling cycle.

The grill- / roasting pan is on

a wrong shelf position.

Remove the residual water

and the descaling agent

from the bottom of the

oven. Put the grill- / roasting

pan on the first shelf posi-

tion.

The cleaning function is in-

terrupted before it finishes.

There was a power cut. Repeat the procedure.

The cleaning function is in-

terrupted before it finishes.

The function was stopped by

the user.

Repeat the procedure.

There is too much water on

the bottom of the cavity af-

ter the end of the cleaning

function.

You sprayed too much de-

tergent in the appliance be-

fore the activation of the

cleaning cycle.

Cover all parts of the cavity

with a thin layer of the deter-

gent. Spray the detergent

evenly.

There is no good perform-

ance of the cleaning proce-

dure.

The initial oven cavity tem-

perature of the steam clean-

ing function was too high.

Repeat the cycle. Run the cy-

cle when the appliance is

cold.

www.aeg.com50

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56

Commentaires sur ces manuels

Pas de commentaire