AEG BSE782320M Manuel d'utilisateur télécharger pdf (Page 46)

2

3

1

2. Pull the front end of the shelf support

away from the side wall.

3. Pull the supports out of the rear

catch.

Install the shelf supports in the opposite

sequence.

12.4 Steam Cleaning

Remove as much dirt as possible

manually.

Remove the accessories and the shelf

support to clean the side walls.

The steam cleaning functions support

the steam cavity cleaning of the oven.

Before you start a cleaning procedure,

make sure that the oven is cool.

When the steam cleaning function works,

the light is off.

1. Fill the water drawer to the maximum

level (around 950 ml of water) until a

signal sounds or the display shows

the message.

2. Choose the steam cleaning function

in the menu: Cleaning.

Steam Cleaning - the duration of the

function is around 30 minutes.

a) Turn on the function.

b) When the programme ends a

signal sounds.

c) Press a sensor field to turn off the

signal.

Steam Cleaning Plus - the duration

of the function is around 75 minutes.

a) Spray a suitable detergent

uniformly in the oven cavity on

both enamel and steel parts.

b) Turn on the function.

The first part of the programme

ends after around 50 minutes.

c) Press

.

Follow the message

in the display to

complete the

cleaning.

d) Wipe the cavity of the oven with

a non-abrasive surface care

sponge. You can use warm water

or oven detergents.

e) Press .

The final part of the procedure

starts. The duration of this stage

is around 25 minutes.

3. Wipe the cavity of the oven with a

non-abrasive sponge. You can use

warm water.

After cleaning keep the oven door open

for approximately 1 hour. Wait until the

oven is dry. To speed up the drying you

can heat up the oven with hot air at

temperature 150 °C for approximately 15

minutes. You can get maximum effects of

the cleaning function if you manually

clean the oven immediately after the

function ends.

12.5 Cleaning Reminder

When reminder is displayed cleaning is

necessary. Perform the function Steam

Cleaning Plus.

You can enable / disable the function:

Cleaning Reminder in the menu: Basic

Settings.

12.6 Steam generation system

- Descaling

When the steam generator operates,

limestone accumulates inside it (because

of calcium contents in the water). This

can have a negative effect on the steam

quality, on the performance of the steam

generator and on the food quality. To

prevent limestone accumulation, clean

the steam generation circuit.

Remove all accessories.

Select the function from the menu:

Cleaning. The user interface will guide

you through the procedure.

The duration of the complete procedure

is about 2 hours.

The light in this function is off.

www.aeg.com

46

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 55 56

Commentaires sur ces manuels

Pas de commentaire