AEG BS9314001M Manuel d'utilisateur télécharger pdf (Page 45)

Install the shelf supports in the opposite

sequence.

13.3 Steam Cleaning

Remove the worst dirt manually.

1. Put 250 ml of water with 3

tablespoons of vinegar directly into

the steam generator.

2. Activate the function: Steam

Cleaning.

The display shows the duration of the

function. An acoustic signal sounds when

the programme is completed.

3. Touch any symbol to deactivate the

signal.

4. Wipe out the appliance with a soft

cloth. Remove the water from the

steam generator.

Keep the appliance door open for

approximately 1 hour. Wait until the

appliance is dry. To speed up the drying

you can heat up the appliance with hot

air at temperature 150 °C for

approximately 15 minutes.

13.4 Steam generation system

CAUTION!

Dry the steam generator

after each use. Remove the

water with the sponge.

Remove the limescale with

water and vinegar.

CAUTION!

Chemical de-scaling agents

can cause damage to the

enamel. Follow the

instructions of the

manufacturer.

1. To clean the water drawer and the

steam generator, put the water and

vinegar mixture (approximately 250

ml) through the water drawer into the

steam generator. Wait for

approximately 10 minutes.

2. Remove the water and vinegar with

the sponge.

3. Put clean water (100 - 200 ml) into the

water drawer to flush the steam

generation system.

4. Remove the water from the steam

generator with the sponge and rub it

dry.

5. Keep the door open to let the

appliance dry fully.

13.5 Removing and installing

the door

You can remove the door and the

internal glass panels to clean it. The

number of glass panels is different for

different models.

WARNING!

Be careful when you remove

the door from the appliance.

The door is heavy.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

A

A

3. Close the oven door to the first

opening position (approximately 70°

angle).

4. Hold the door with one hand on each

side and pull it away from the

appliance at an upwards angle.

5. Put the door with the outer side

down on a soft cloth on a stable

surface. This is to prevent scratches.

6. Hold the door trim (B) on the top

edge of the door at the two sides

and push inwards to release the clip

seal.

1

2

B

7. Pull the door trim to the front to

remove it.

ENGLISH

45

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 55 56

Commentaires sur ces manuels

Pas de commentaire