AEG ABE81816NC Manuel d'utilisateur télécharger pdf (Page 13)

Problem Possible cause Solution

The "FROSTMATIC" is

switched on.

Refer to "FROSTMATIC func-

tion".

There is too much frost and

ice.

The door is not closed cor-

rectly or the gasket is de-

formed/dirty.

Refer to "Closing the door".

The compressor does not

start immediately after

pressing the "FROSTMAT-

IC", or after changing the

temperature.

This is normal, no error has

occurred.

The compressor starts after a

period of time.

Temperature cannot be set. The "FROSTMATIC func-

tion" is switched on.

Switch off "FROSTMATIC

function" manually, or wait un-

til the resets automatically to

set the temperature. Refer to

"FROSTMATIC function".

dEMo appears on the dis-

play.

The appliance is in demon-

stration mode.

Keep the OK pressed for ap-

proximately 10 seconds until a

long sound is heard and dis-

play shuts off for a short time.

The temperature in the ap-

pliance is too low/too high.

The temperature regulator

is not set correctly.

Set a higher/lower tempera-

ture.

The food products' tem-

perature is too high.

Let the food products temper-

ature decrease to room tem-

perature before storage.

The door has been

opened often.

Open the door only if necessa-

ry.

The "FROSTMATIC func-

tion" is switched on.

Refer to "FROSTMATIC func-

tion".

There is no cold air circula-

tion in the appliance.

Make sure that there is cold air

circulation in the appliance.

If the advice does not lead

to the desired result, contact

the nearest Authorised

Service Centre.

8.2 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

assembly instructions.

3. If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.

9. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire