AEG DI9966-M Manuel d'utilisateur Page 4

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 128
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 3
4
www.aeg.com
4. CONTROLS
R
HGF
E
DC
BA
Button Function Led
A
Turns the lighting system on and o at maximum intensity. On/O
Press and hold for approximately 2 seconds to turn
the lighting system on and o in Courtesy Light mode.
On/O
B
Turns the Motor o.
Press and hold for approximately 5 seconds to Lock
/ Unlock the Keyboard, for example in order to clean
the surface.
All the Leds (Flash twice)-Keyboard Locked.All the
Leds (Flash once)-Keyboard Unlocked.While it is
Locked the Leds light up one at a time in cycle.
C
Turns the Motor on at Speed one. On/O
D
Turns the Motor on at Speed two. On/O
E
Turns the Motor on at Speed three. On/O
Press and hold the button for approximately 5 seconds,
with all the loads turned o (Motor and Lights), to turn
the Activated Charcoal Filter alarm on/o.
Button E LED (Flashes twice)-Alarm Activated.
Button E LED (Flashes once)-Alarm Deactivated.
F
Turns the Motor on at Maximum Speed. This speed is
timed to run for 5 minutes. At the end of this time the
system will automatically return to the speed set before.
Suitable to deal with maximum levels of cooking fumes.
On/O
G
Delay function
Activates/Deactivates automatic switch-o with a 15’ delay.
Suitable to complete elimination of residual odours. Can
be activated from any position. It cannot be activated if
the Intensive function is in use.
On/O
Press and hold the button for approximately 5 seconds,
with all the loads turned o (Motor and Lights), to turn
the Remote control on/o.
Button G LED (Flashes twice)-Remote control
Activated.
Button G LED (Flashes once) - Remote control
Deactivated.
H
When the lters alarm is triggered, the alarm can be
reset by pressing and holding this button for approxi
-
mately 2 seconds.
These indications are only visible when the motor is
turned o.
The Button LED ashes three times.
When the procedure terminates, the indication
shown previously turns o:
Button H lights up, indicating the need to wash the
metal grease lters. The alarm is triggered after the
Hood has been in operation for 100 working hours.
Button H ashes, indicating the need to change
the activated charcoal lters, and also to wash the
metal grease lters. The alarm is triggered after the
Hood has been in operation for 200 working hours.
R
Remote control receiver.
Warning: In order to activate the function press on the symbol
Vue de la page 3
1 2 3 4 5 6 7 8 9 ... 127 128

Commentaires sur ces manuels

Pas de commentaire