AEG L9FSC969R Manuel d'utilisateur télécharger pdf (Page 12)

Salt

Compartment for salt.

Read carefully 'The

Water Softener

technology ( Soft

Water)'.

Maximum level for detergent/

additives quantity.

When selecting a prewash

phase, put the detergent/

additive in a dosing ball

inside the drum.

After a washing cycle, if

necessary, remove any

detergent residue from the

detergent dispenser.

5. THE WATER SOFTENER (SOFTWATER

TECHNOLOGY)

5.1 Introduction

The water contains harsh minerals. The

higher the content of these minerals the

harder the water is.

Hard water can reduce the effectiveness

of the detergent, reduce the softness of

fabrics and contribute towards shrinkage

and colour fading.

This appliance is equipped with a water

softener able to provide the right degree

of water softening to preserve the fabric

integrity, colour brightness and ensuring

good wash performances at low

temperature.

The water softener should be adjusted

according to the water hardness of your

inlet water. A correct setting allows to

achieve the best washing results and the

maximum garments protection.

To set the water softener correctly,

please refer to 'How to set the water

hardness level'.

5.2 How to set the water

hardness level

The appliance allows you to chose

between 7 levels corresponding to 7

different ranges of water hardness.

Depending on the country, the water

hardness is expressed in equivalent

scales: e.g. French degrees (°f), German

degrees (°d), English degrees (°e) and

mmol/l.

If necessary, please contact your local

water authority to check the water

hardness in your area.

Check in the "Water hardness levels"

table which is the proper level.

To set the water hardness level:

1. Press the On/Off button for a few

seconds to activate the appliance.

2. Wait about 10 seconds for appliance

internal check.

3. Touch the Stains/Prewash and the

Plus Steam buttons simultaneously

(by touching the two buttons at the

same instant, as shown in the next

drawing) for some seconds until the

display shows the default level C04

and the indicator

goes on. It

means the water softener is active

during washing only.

www.aeg.com

12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Commentaires sur ces manuels

Pas de commentaire