AEG KS7100000M Manuel d'utilisateur Page 37

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 48
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 36
3.
Pull the support out of the rear catch.
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
STEAM GENERATION SYSTEM
CAUTION!
Dry the steam generator after
each use. Soak up water with the
sponge.
Remove the limescale residue
with water and vinegar.
CAUTION!
Chemical de-scaling agents can
cause damage to the enamel. Fol-
low the instructions of the manu-
facturer.
Cleaning the water drawer and the
steam generator:
1.
Put the water and vinegar mixture
(approximately 250 ml) through the
water drawer into the steam genera-
tor.
Wait for approximately 10 minutes.
2.
Remove the water and vinegar with
the sponge.
3.
Put clean water (100-200 ml) into the
water drawer to flush the steam gen-
eration system.
4.
Remove water from the steam gener-
ator with the sponge and rub dry.
5.
Keep the door open to let the appli-
ance dry fully.
OVEN LAMP
WARNING!
There is a risk of electrical shock.
The oven lamp and the lamp glass
cover can be hot.
Before you change the oven lamp:
Deactivate the appliance.
Remove the fuses from the fuse box or
deactivate the circuit breaker.
CAUTION!
Put a cloth on the bottom of the
interior of the appliance. It pre-
vents damage to the lamp glass
cover and the cavity.
Replacing the side lamp:
1.
Remove the left shelf support.
2.
Use a torx 20 screwdriver to remove
the cover.
3.
Remove and clean the metal frame
and the seal.
4.
Replace the lamp with a suitable 300
°C heat-resistant lamp.
Use the same oven lamp type.
5.
Install the metal frame and the seal.
Tighten the screws.
6.
Install the left shelf support.
OVEN DOOR
Remove the door to clean the inner side
of the appliance more easily.
ENGLISH
37
Vue de la page 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

Commentaires sur ces manuels

Pas de commentaire