AEG HVB95450IB Manuel d'utilisateur télécharger pdf (Page 10)

6. Touch or .

To increase or decrease the value and

adjust the minimum level.

7. Wait 5 seconds.

To send the selected value to power

board.

8. Check it the minimum level is correct

and touch .

To confirm the minimum level.

If the minimum level is

incorrect, repeat the steps 6

and 7.

9. Touch to select the next burner

and repeat the steps 5-8.

Touch to exit the mode.

WARNING!

Make sure the flame does

not go out when you move

quickly from the maximum

to the minimum heat setting

position.

WARNING!

Do not set the G3 and G4

modes. It is for authorised

installer only.

3.7 Electrical connection

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug (if applicable).

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of

fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the

cabinet, in order to avoid any contact

with the appliance beneath the

cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations.

For your own safety the installation must

be done by a qualified electrician (e.g.

your local Electricity Board, or a

contractor who is on the roll of the

National Inspection Council for Electrical

Installation Contracting [NICEIC]).

The manufacturer refuses

to be held responsible, if

these safety measures are

not abided by.

Supply connections

This hob has to be connected to 220-240

V (~ 50/60 Hz ) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

or E — Earth terminal

Before carrying out the connection,

make sure:

1. The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

2. The supply system is equipped with

an efficient earth connection in

compliance with the current

standards and regulations

3. The outlet or omnipolar switch used

for connection is easily accessible

with the appliance installed.

The appliance is supplied with a 3 core

flexible power cable.

The wires in the cord are coloured as

follows:

Green and yellow - Earth

Blue - Neutral

Brown - Live

WARNING!

A cut off plug inserted into a

13 amp socket is a serious

shock hazard. Ensure that

the cut off plug is disposed

of safely.

www.aeg.com10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Commentaires sur ces manuels

Pas de commentaire