AEG L 98499 FL Manuel d'utilisateur

L 98499 FLL 98699 FLWASHING MACHINE USER MANUAL

DISPLAY 3ABCDEFGHIJAThe text bar:• Guides you in the use of the appliance.• Shows the programme status and phase.• Shows alarm messages. Refer to &apo

•The time of delay– When you set the delayed start the time of the programme end in-creases by steps of 30 minutes till 10 hours and by steps of oneho

Rinse hold1) Only available for Spin/Drain programme.JThe default temperature of the programme.Cold washDAMPF BUTTON 4Touch button 4 to set the steam

VORWÄSCHEUse this function for heavy soil.The appliance adds a prewash phase tothe main wash.The programme duration increases.EINWEICHENUse this funct

WASHING PROGRAMMESProgramme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsKoch/Bunt 95° - Cold White and col-oured cottonwith hea

Programme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsFeinwäsche 40° - ColdRinsesShort spinDelicate fabricsas acrylics, vis-cos

Programme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsSpülen 0° All fabricsMaximum load 9kgRinse with ad-ditivesSpin phaseSPIN

7) Press button to add rinses. With a low spin speed the appliance performs delicate rinsesand a short spin.8) Use a special detergent for very low te

Standard programmes for theEnergy Label consumptionvaluesThe cotton 60 °C economy and cotton40 °C economy are the standard cottonprogrammes for normal

ACTIVATING THE APPLIANCE AND SETTING A PROGRAMMEFor a correct operation of the weight sensor, activate the appliance andset the programme BEFORE you p

SERVICEWhen contacting Service, ensure thatyou have the following data available.The information can be found on therating plate.ModelPNCSerial Numbe

Make sure not to have the laundry outof the drum between the seal and thedoor. There is the risk of water leakageor damage laundry.USING THE DETERGENT

Check the position of the flap1. Pull out the detergent dispenseruntil it stops.2. Press the lever down to remove thedispenser.3. To use powder deterg

SET THE DELAY START1.Touch button 7 again and againto set the desired delayed start.The display shows the expectedend of the programme2.Touch button 6

If you deactivate the appliance,it is necessary to set the pro-gramme again.AT THE END OF PROGRAMME1. The appliance stops automatically.2. The acousti

HELPFUL HINTS AND TIPSTHE LAUNDRY LOAD• Divide the laundry in: white, col-oured, synthetics, delicates and wool.• Obey the washing instructions thatar

Water hardness tableLevel TypeWater hardness°dH °T.H. mmol/l Clarke1 soft 0-7 0-15 0-1.5 0-92 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.

CARE AND CLEANINGWARNING!Disconnect the appliance from themains supply before you clean it.DESCALINGThe water we use contains limescale. Ifit becomes

DETERGENT DISPENSERTo clean the dispenser:121. Press the lever.2. Pull the dispenser out.3. Remove the top part of the liquidadditive compartment.4. C

To clean the drain pump:1. Open the drain pump door.2. Pull the flap out to remove it.3. Put a container below the recess ofthe drain pump to collect

129. Clean the filter under the water tapand put it back in the pump intothe special guides.10. Make sure that you tighten correct-ly the filter to pr

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

When you drain the water with theemergency drain procedure, you mustactivate again the drain system:1. Put 2 litres of water in the mainwash compartme

TROUBLESHOOTINGThe start of the appliance does not oc-cur or it stops during operation.Try to find a solution to the problembefore you contact the ser

PROBLEM WITHOUT ALARM MESSAGEProblem Possible cause Possible solutionThe appliancedoes not drainthe water.A washing programmewithout the drain phaseis

Problem Possible cause Possible solution You did not remove thepackaging and/or thetransit bolts.Remove the packaging and/orthe transit bolts. Refer

INSTALLATIONUNPACKING1. Use the gloves. Remove the exter-nal film. If necessary, use a cutter.2. Remove the cardboard top.3. Remove the polystyrene pa

6. Put the polystyrene front piece onthe floor behind the appliance.Carefully put down the appliancewith the rear side on it. Make surenot to damage t

x4AB10. – Remove the adhesive strip fromthe silent barriers.– Attach the four barriers to bot-tom of the appliance. Refer tothe illustration.– Make su

14. Replace the plastic spacers withthe plastic caps. You can find thesecaps in the user manual bag.WARNING!Remove all the packaging andthe transit bo

THE INLET HOSE35O35O35O45O45O45O• Connect the hose to the appliance.Turn the inlet hose only left or right.Loose the ring nut to set it in the cor-rec

With the plastic hose guide. • On the edge of a sink.• Make sure that the plastic guide can-not move when the appliance drains.Attach the guide to the

SAFETY INFORMATIONBefore the installation and use, readthis manual carefully:• For your safety and the safety of yourproperty• To help the environmen

You can extend the drain hoseto maximum 400 cm. Contactthe service centre for the otherdrain hose and the extension.40

ENGLISH 41

42

ENGLISH 43

www.aeg.com/shop 132940573-A-232011

WARNING!Do not look directly into thebeam of the lamp.To replace the internal lamp,contact the service centre.Disconnect the mains plug fromthe mains

ENVIRONMENT CONCERNSPACKAGING MATERIALSRecycle the materials with the symbol .Put the packaging in applicable con-tainers to recycle it.ECOLOGICAL HI

PRODUCT DESCRIPTION1 2 3910657841112131Worktop2Detergent dispenser3Control panel4Door handle5Internal lamp6Rating plate7Drain pump8Feet for the applia

CONTROL PANELWolle/SeideKoch/BuntExtra LeisePflegeleichtLeichtbügelnFeinwäscheDaunenAnti-Allergie Schleudern/Pumpen SpülenOutdoor 20Min. - 3kgSup

ENVIRONMENT CONCERNSPACKAGING MATERIALSRecycle the materials with the symbol .Put the packaging in applicable con-tainers to recycle it.ECOLOGICAL HI