AEG KFA58SIO Manuel d'utilisateur télécharger pdf (Page 15)

7.2 If you cannot find a

solution...

If you cannot find a solution to the

problem yourself, contact your dealer or

an Authorised Service Centre. Give the

data from the rating plate. Give also

three digit letter code for the glass

ceramic (it is in the corner of the glass

surface) and an error message that

comes on. Make sure, you operated the

hob correctly. If not the servicing by a

service technician or dealer will not be

free of charge, also during the warranty

period. The instructions about the

Service Centre and conditions of

guarantee are in the guarantee booklet.

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Serial number ...........................

8.2 Built-in hobs

Only use the built-in hobs after you

assemble the hob into correct built-in

units and work surfaces that align to the

standards.

During installation in combustible

matter, NIN SEV 1000 and fire protection

guidelines and regulations of the

Association of Cantonal Fire Insurance

shall be strictly adhered to.

8.3 Connection cable

• The hob is supplied with a connection

cable.

• To replace the damaged mains cable

use the following (or higher) mains

cable type: H05V2V2-F T min 90°C.

Speak to your local Service Centre.

8.4 Electrical connection

Install the hob with a socket supply line.

If there is no socket supply line, the fixed

home electrical system must include an

isolating device with at least a 3 mm-

contact separation to enable a

simultaneous and all-pole cut off from

the mains (according to NIN SEV 1000).

8.5 Attaching the seal to the

rabbet

1. Clean the rabbets in the worktop.

2. Cut the supplied seal stripe into 4

stripes. The stripes must have the

same length as the rabbets.

3. Cut the ends of the stripes at an

angle of 45°. They should fit in the

corners of the rabbets accurately.

4. Attach the stripes to the rabbets. Do

not extend the stripes. Do not bond

ends of stripes one over another.

After you assemble the hob, seal the

remaining gap between glass ceramic

and the worktop with silicone. Make sure

the silicone does not get under the glass

ceramic.

ENGLISH

15

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire