AEG L6FBI841N Manuel d'utilisateur

USER MANUALEN User ManualWashing MachineL6FBI841N

6. Position the hose directly to a built-in drain pipe in the room wall andtighten it with a clamp.4. PRODUCT DESCRIPTION4.1 Special featuresYour new

5. CONTROL PANEL5.1 Control panel descriptionCottonsCotton EcoSyntheticsDelicates20 min. - 3kgCotton 20°DuvetEasy IronDrain/SpinOn/OWool/SilkProgramm

A The digital indicator can show:• Programme duration (e. g. ).• Delay time (e. g. or ).• Cycle end ( ).• Warning code ( ).B Extra rinse indicator

The appliance empties thewater out automatically after18 hours approximately.Activate the No spin option• Set this option to deactivate all spinphases

7. PROGRAMMES7.1 Programme ChartWashing programmesProgramme Programme descriptionWashing programmesCottonsWhite cotton and coloured cotton. Normal soi

Programme Programme descriptionDrain/SpinTo spin the laundry and to drain the water in the drum. All fab-rics, except woollens and delicate fabrics.1)

Programme options compatibilityProgrammeCottons Cotton Eco Synthetics Delicates Wool/Silk 20 min. - 3 kg Cotton 20° DuvetEasy Iron Drain/SpinOptionsSp

indicator comes on/goes off onthe display.You can activate this option:• After you touch the Start/Pausebutton: all the buttons and theprogramme dia

CAUTION!Make sure that no laundrystays between the seal andthe door. There is a risk ofwater leakage or damage tothe laundry.10.3 Filling the detergen

With the flap in theposition DOWN:• Do not usegelatinous or thickliquid detergents.• Do not put moreliquid detergent thanthe limit shown onthe flap.•

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...

10.8 The ProSense loaddetectionAfter touching the Start/Pause buttonthe ProSense technology starts thelaundry load detection:1. The appliance detects

When you activate theappliance again, the displayshow the end of the lastselected programme. Turnthe programme dial to set anew cycle.2. Remove the la

• Do not wash laundry without hems orwith cuts. Use a washing bag to washsmall and/or delicate items (e.g.underwired bras, belts, tights, etc. ).• A v

CAUTION!Do not use alcohol, solventsor chemical products.CAUTION!Do not clean the metalsurfaces with chlorine-baseddetergent.12.2 DescalingIf the wate

3. Make sure that all detergent residueis removed from the upper and lowerpart of the recess. Use a small brushto clean the recess.4. Insert the deter

without removing. Let the water flowout.5. When the bowl is full of water, turnthe filter back and empty thecontainer.6. Repeat the steps 4 and 5 unti

1232. Remove the inlet hose from theappliance by loosening the ring nut.3. Clean the valve filter on the back ofthe appliance with a toothbrush.4. Whe

persists, contact the Authorised ServiceCentre.In case of major problems, the acousticsignals operate, the display shows analarm code and the Start/Pa

Problem Possible solutionThe appliance does notdrain the water.• Make sure that the sink spigot is not clogged.• Make sure that the drain hose has no

Problem Possible solutionToo much foam in thedrum during the washingcycle.• Reduce the quantity of detergent.After the washing cycle,there are some de

1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible f

Programmes Load(kg)Energyconsump-tion (kWh)Waterconsump-tion (litre)Approxi-mate pro-grammeduration(minutes)Remain-ing mois-ture (%)1)Standard 60°C co

16. ACCESSORIES16.1 Available inwww.aeg.com/shop or fromauthorised dealerOnly appropriateaccessories approved byAEG ensure the safetystandards of the

www.aeg.com/shop192947911-A-202017

• The appliance must be connected to the water mainsusing the new supplied hose sets, or other new hosesets supplied by the Authorised Service Centre.

electrical ratings of the mains powersupply.• Do not use multi-plug adapters andextension cables.• Make sure not to cause damage tothe mains plug and

3. INSTALLATIONWARNING!Refer to Safety chapters.3.1 UnpackingWARNING!Remove all the packagingand the transit bolts beforeinstalling the appliance.WARN

9. Remove the power supply cable andthe drain hose from the hose holders.It is possible to seewater flowing from thedrain hose. This is due tothe test

x4The appliance must be level and stable.A correct adjustment of theappliance level prevents thevibration, noise and themovement of the appliancewhen

You can extend the drainhose to maximum 400 cm.Contact the authorizedservice centre for the otherdrain hose and theextension.It is possible to connect