AEG L16810 Manuel d'utilisateur télécharger pdf (Page 51)

Water inlet (cold water connection only)

Connect the hose to a tap with a 3/4” thread.

Installation should comply with local water authority and building

regulations’ requirements.

The inlet hose is provided with a water stop

device, which protects against damage

caused by water leaks in the hose which

could develop due to natural ageing of the

hose. This fault is shown by a red sector in

the window “A”. Should this occur, turn the

water tap off and refer to your Service Force

Centre to replace the hose.

Set the hose correctly by loosening the ring nut. After positioning the

inlet hose, be sure to tighten the ring nut again to prevent leaks.

Do not connect to a hot water supply.

Water drainage

The appliance drain hose should hook into a

standpipe, the hook in the drain hose is

formed using the plastic “U-Piece” supplied.

The standpipe should have an internal

diameter of approximately 38 mm (see dia-

gram on page 52) thus ensuring there is an

air break between the drain hose and stand-

pipe.

When discharging into a standpipe ensure

that the top of the curve in the hose end is

no more than 90 cm (35.4”)

and no less than 60 cm (23.6”)

above floor level.

Installation

3 pin

Max. 90 cm.(35.4")

Min.60 cm.(23.6")

132995620.qxd 2/12/03 3:35 PM Pagina 51 (Nero/Process Black pellicola)

1 2 ... 46 47 48 49 50 51 52 53 54 55

Pas de commentaire

AEG L16810 Manuel d'utilisateur Page 51