AEG UN 6.03 Informations techniques télécharger pdf (Page 66)

Practical A.E.G Upgrade 2006

Use of spacers for spring compression: tricks and potential danger.

When you want to put spacer on the spring guide to increase the compression

effect, first look for spacer of suitable diameter. Referring back to this picture:

The sector gear keeps rotating anti-clockwise, and the piston is being driven all

the way to the leftmost position. If your spacer has an outside diameter

exceeding the inside diameter of the piston and that the spacer is too thick

(anything getting close to half an inch is considered too thick here), the piston’s

leftward movement will be blocked and the gun will get locked up.

Even if your spacer has a piston-safe diameter, use it very carefully with stock

TM piston set. Referring back to the TM type Piston Head we talked about, the

metal spacer unit itself is already a thick spacer. The use of additional spacer is

no different from using a spring that is too long – something will break inside the

mechbox (refer to our Troubleshooting section).

If spacer is used inside the piston (rather than with the spring guide), make sure

the spring guide won’t hit the spacer during full compression:

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 156 157

Pas de commentaire

AEG UN 6.03 Informations techniques Page 66