AEG UN 6.03 Informations techniques télécharger pdf (Page 148)

Practical A.E.G Upgrade 2006

you want to use metal gears, you will need to drill holes on the mechbox to

accommodate bushings. This process is likely to be imprecise. Mixing and

matching plastic gears with metal gears is a real bad idea – it can accelerate the

killing of the plastic gears dramatically. Staying with the stock plastic gears is

your best bet.

The stock cylinder is a plastic made one-piece cylinder. It is good at air sealing.

However, because of its small volume, improper air volume balancing is resulted

on the AUG (remember, the AUG has a damn long barrel). To effectively increase

FPS, replace the stock cylinder set AND the piston with a bore up set. Keep in

mind that:

1. You can’t use the stock piston in a TM cylinder. The stock one is about 5%

smaller. If you are to replace the cylinder, you MUST also replace the

piston.

2. You can’t use the stock air nozzle with a TM cylinder set. The stock one has

an inner diameter too large to give room for air leakage.

3. If you use a TM compatible air nozzle, minor cutting work is necessary for

it to fit into the stock tappet plate.

A PDI 120 / Guarder SP90 is a decent spring upgrade option for the plastic

mechbox. Don’t use Systema M series spring on it, they are too stiff for the

plastic mechbox to sustain.

To fix the foregrip wobble issue, simply add a thin washer to either side of the

fore grip assembly. Note that the TM high cap does not fit with the BE Tech guns

without modifications. However, you can install the internals of the TM high cap

into the stock mag shell – they will work together well, we have been doing that

since day one ☺

For more coverage on the BE Tech guns, please refer to our Practical LPEG

Upgrade ebook.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 156 157

Pas de commentaire

AEG UN 6.03 Informations techniques Page 148