AEG DBS3340 Manuel d'utilisateur télécharger pdf (Page 9)

9www.aeg.com

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE SOLUTION

Soleplate is not heating even though

iron is turned on.

Connection problem Check main power supply cable, plug

and outlet.

Temperature control is in MIN position. Select adequate temperature.

Iron does not produce steam. Not enough water in tank. Fill water tank (see “Getting started”).

Steam control is selected in non-steam

position.

Set steam control between positions of

minimum steam and maximum steam.

(see “Ironing chart”)

Selected temperature is lower than

that specied to use with steam.

Increase temperature to at least

Steam jet and vertical steam jet

function does not work.

Steam jet function was used very

frequently within a short period.

Put iron on horizontal position and wait

before using steam jet function.

Iron is not hot enough. Adjust the proper temperature to steam

ironing (up to

). Put iron in vertical

position and wait until temperature

indicator light turns o.

Water leaks from the soleplate during

ironing.

The iron is not hot enough. Set the temperature dial to a

temperature

(

to maximum) suitable for steam

ironing. Put the iron on its heel and wait

until the light has gone out before you

start ironing.

Flakes and impurities come out of the

soleplate during ironing.

You have used hard water, which has

caused scale akes to develop in the

water tank.

Press and hold the steam button for

about one minute to get steam. Then

hold one more minute in order to clean

the steam generating system.

Iron an old towel, to ensure that

any residues inside the iron are not

transferred to the laundry.

Water leaks from the soleplate while

the iron is cooling down or after it has

been stored.

The iron has been put in horizontal

position while there is still water in the

water tank.

Empty the water tank and set the steam

control to position o before storing

the iron.

Brown streaks come out of the

soleplate while ironing and stain the

linen.

You have used chemical descaling

agents.

Do not use any descaling agents.

Fabric bres have accumulated in the

holes of the soleplate and are burning.

Clean the soleplate with a damp soft

cloth.

Fabrics might not be properly rinsed

or the garments are new and have not

been washed before ironing.

Please rinse the laundry properly again.

DISPOSAL

This symbol on the product indicates that this product contains a battery which shall not be disposed with

normal household waste.

This symbol on the product or on its packaging indicates that the product may not be treated as household

waste. To recycle your product, please take it to an oicial collection point or to an AEG service center that can

remove and recycle the battery and electric parts in a safe and professional way. Follow your country’s rules for

the separate collection of electrical products and rechargeable batteries.

AEG reserves the right to change products, information and specications without notice.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

AEG DBS3340 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Fers à repasser AEG DBS3340