AEG HVB95450IB Manuel d'utilisateur télécharger pdf (Page 8)

Choose fixed connections or use a

flexible pipe in stainless steel in

compliance with the regulation in force.

If you use flexible metallic pipes, be

careful they do not come in touch with

mobile parts or they are not squeezed.

Also be careful when the hob is put

together with an oven.

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values.

If the supplied pressure has not the

specified value, it is necessary to

assemble a proper pressure regulator in

compliance with the standard UNI EN 88.

For Liquid Gas (LPG) the use of pressure

regulator is allowed only if they are in

compliance with UNI EN 12864. The

adjustable connection is fixed to the

comprehensive ramp by means of a

threaded nut G 1/2". Screw the parts

without force, adjust the connection in

the necessary direction and tighten

everything.

A

A. End of shaft with nut

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end) (UNI-

CIG 7129).

Flexible connection:

Use a flexible pipe in stainless steel (UNI-

CIG 9891) with a maximum length 2 m.

WARNING!

When installation is

complete, make sure that

the seal of each pipe fitting

is correct. Use a soapy

solution, not a flame!

3.3 Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in

"Technical Data" chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure

adjuster on the gas supply pipe.

3.4 Gas selection

1. Touch for 3 seconds.

2. Within 7 seconds, touch for 3

seconds.

3. Touch 3 times.

The display shows G1 mode.

4. Touch .

To enter the mode.

5. Timer display shows selected gas

type.

6. Touch

to set the gas type

according to table below.

7. Touch .

To confirm the gas type.

Touch

to exit the mode or wait for

Automatic Switch Off function activates.

www.aeg.com

8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 79 80

Commentaires sur ces manuels

Pas de commentaire