AEG HVB95450IB Manuel d'utilisateur télécharger pdf (Page 10)

4.3 Adjustment of minimum

level

WARNING!

Information for authorised

installer only.

Switch off the hob before

the adjustment.

To adjust the minimum level of the

burners:

1. Touch for 3 seconds.

2. Within 7 seconds, touch for 3

seconds.

3. Touch 4 times.

The display shows G2 mode.

4. Touch

.

To enter the mode.

5. Wait 5 seconds, after selecting the

mode.

The burner shows minimum level and the

control bar shows .

6. Touch

or .

To increase or decrease the value and

adjust the minimum level.

7. Wait 5 seconds.

To send the selected value to power

board.

8. Check it the minimum level is correct

and touch .

To confirm the minimum level.

If the minimum level is

incorrect, repeat the steps 6

and 7.

9. Touch to select the next burner

and repeat the steps 5-8.

Touch to exit the mode.

WARNING!

Make sure the flame does

not go out when you move

quickly from the maximum

to the minimum heat setting

position.

WARNING!

Do not set the G3 and G4

modes. It is for authorised

installer only.

4.4 Electrical connection

The appliance is supplied with a

standard 7.5 Amp service cord

terminated by a 3-pin plug for

connection to a standard household

socket. The electrical supply is required

to power the electronic ignition system.

To disconnect the electrical

power supply, it is necessary

to service. After installation,

the power point should be

accessible according to local

wiring regulations.

• Make sure that the rated voltage and

type of power on the rating plate

agree with the voltage and the power

of the local power supply.

• This appliance is supplied with a

mains cable and a plug.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the

appliance is in connection with an

extension cable, an adapter or a

multiple connection. Make sure that

the ground connection agrees with

the standards and regulations.

• Do not let the power cable to heat up

to a temperature higher than 90° C.

Make sure that you connect

the blue neutral cable to the

terminal with a letter "N" on

it. Connect the brown (or

black) phase cable to the

terminal which has a letter

"L". Keep the phase cable

connected at all times.

To prevent contact between

the cable and the appliance

below the hob use the

clamps which are on the side

of the cabinet.

www.aeg.com10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Commentaires sur ces manuels

Pas de commentaire