AEG HG694340XB Manuel d'utilisateur télécharger pdf (Page 11)

8. INSTALLATION

WARNING!

Refer to the Safety chapters.

WARNING!

The following instructions about

installation, connection and

maintenance must be carried out

by qualified personnel in compli-

ance with standards and local

regulations in force.

8.1 Important safety

requirements

This hob must be installed in accordance

with the Gas Safety (Installation and Use)

Regulations (Current Edition) and the IEE

Wiring Regulations (Current Edition).

For appliances installed in the Republic

of Ireland please refer to NSAI- Domes-

tic Gas Installation I.S. 813 Current Edi-

tions and the ETCI Rules for Electrical In-

stallations.

Provision for ventilation

Detailed recommendations are con-

tained in the following British Standards

Codes Of Practice: B.S. 6172/ B.S. 5440,

Par. 2 and B.S. 6891 Current Editions.

The hob should not be installed in a bed

sitting room with a volume of less than

20 m³. If it is installed in a room of vol-

ume less than 5 m³ an air vent of effec-

tive area of 100 cm² is required. If it is in-

stalled in a room of volume between 5

m³ and 10 m³ an air vent of effective area

of 50 cm² is required, while if the volume

exceeds 11 m³ no air vent is required.

However, if the room has a door which

opens directly to the outside no air vent

is required even if the volume is be-

tween 5 m³ and 11 m³.

If there are other fuel burning appliances

in the same room, B.S. 5440 Part 2 Cur-

rent Edition, should be consulted to de-

termine the requisite air vent require-

ments.

For appliances installed in the Republic

of Ireland please refer to the NSAI- Do-

mestic Gas Installation I.S. 813 Current

Editions Table Four.

Location

The hob may be located in a kitchen, a

kitchen/diner or bed sitting room (with a

volume greater than 20 m³), but not in a

bathroom or shower room.

The minimum distance combustible ma-

terial can be fitted above the hob in line

with the edges of the hob is 400 mm. If it

is fitted below 400 mm a space of 50 mm

must be allowed from the edges of the

hob.

For appliances installed in the Republic

of Ireland please refer to NSAI- Domes-

tic Gas Installation I.S 813 Current Edi-

tion Section 7- Permitted Locations of

Appliance.

8.2 Gas Connection

WARNING!

Any gas installation must be car-

ried out by a GAS SAFE REGIS-

TER installer.

Make sure that, once the hob is instal-

led, it is easily accessible for the engi-

neer in the event of a breakdown.

The manufacturer will not accept liability,

should the above instructions or any of

the other safety instructions incorpora-

ted in this instruction booklet be ignor-

ed.

On the end of the shaft, which includes

the G 1/2" threaded elbow, adjustment

is fixed so that the washer is fitted be-

tween the components as shown in the

diagram. Screw the parts together with-

out using excessive force.

ABC

A)

End of shaft with nut

B)

Washer

C)

Elbow

Connection to the gas supply should be

with either rigid or semi-rigid pipe, i.e.

steel or copper.

ENGLISH 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Commentaires sur ces manuels

Pas de commentaire