Aeg HG694340XB Manuel d'utilisateur télécharger pdf (Page 14)

INSTALLATION

WARNING!

Refer to "Safety information"

chapter.

WARNING!

The following instructions about

installation, connection and main-

tenance must be carried out by

qualified personnel in compliance

with standards and local regula-

tions in force.

IMPORTANT SAFETY

REQUIREMENTS

This hob must be installed in accordance

with the Gas Safety (Installation and Use)

Regulations (Current Edition) and the IEE

Wiring Regulations (Current Edition).

For appliances installed in the Republic of

Ireland please refer to NSAI- Domestic

Gas Installation I.S. 813 Current Editions

and the ETCI Rules for Electrical Installa-

tions.

Provision for ventilation

Detailed recommendations are contained

in the following British Standards Codes

Of Practice: B.S. 6172/ B.S. 5440, Par. 2

and B.S. 6891 Current Editions.

The hob should not be installed in a bed

sitting room with a volume of less than 20

m³. If it is installed in a room of volume

less than 5 m³ an air vent of effective area

of 100 cm² is required. If it is installed in a

room of volume between 5 m³ and 10 m³

an air vent of effective area of 50 cm² is

required, while if the volume exceeds 11

m³ no air vent is required.

However, if the room has a door which

opens directly to the outside no air vent is

required even if the volume is between 5

m³ and 11 m³.

If there are other fuel burning appliances

in the same room, B.S. 5440 Part 2 Cur-

rent Edition, should be consulted to de-

termine the requisite air vent require-

ments.

For appliances installed in the Republic of

Ireland please refer to the NSAI- Domes-

tic Gas Installation I.S. 813 Current Edi-

tions Table Four.

Location

The hob may be located in a kitchen, a

kitchen/diner or bed sitting room (with a

volume greater than 20 m³), but not in a

bathroom or shower room.

The minimum distance combustible mate-

rial can be fitted above the hob in line

with the edges of the hob is 400 mm. If it

is fitted below 400 mm a space of 50 mm

must be allowed from the edges of the

hob.

For appliances installed in the Republic of

Ireland please refer to NSAI- Domestic

Gas Installation I.S 813 Current Edition

Section 7- Permitted Locations of Appli-

ance.

GAS CONNECTION

WARNING!

Any gas installation must be car-

ried out by a GAS SAFE REGIS-

TER installer.

Make sure that, once the hob is installed,

it is easily accessible for the engineer in

the event of a breakdown.

The manufacturer will not accept liability,

should the above instructions or any of

the other safety instructions incorporated

in this instruction booklet be ignored.

On the end of the shaft, which includes

the G 1/2" threaded elbow, adjustment is

fixed so that the washer is fitted between

the components as shown in the diagram.

Screw the parts together without using

excessive force.

ABC

A)

End of shaft with nut

B)

Washer

C)

Elbow

Connection to the gas supply should be

with either rigid or semi-rigid pipe, i.e.

steel or copper.

14

www.aeg.com

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire