AEG KF 31xx Manuel de service télécharger pdf (Page 31)

Operating Manual for AViTEQ Small Conveyor Units KF and KR

4–1

4 Selection and Installation of

the Controller

Chapter outline

The drives of the small conveyor units must always be connected to the AC mains

using the appropriate controller. A suitable AViTEQ-VIBTRONIC controller is availa-

ble for each version of the small conveyor units.

The chapter gives an overview over the possible combinations, the technical data,

and the terminology.

Individual information, connection options, and wiring diagrams may be found in a

separate, additional manual that is included with each controller.

4.1 Suitable controllers

The small conveyor units must be operated and connected via a special controller

to an AC mains with 50 or 60 Hz. The controllers are either included in the ship-

ment from AViTEQ, or may be obtained from third party manufacturers under cer-

tain circumstances.

4.2 VIBTRONIC controllers

The VIBTRONIC controllers recommended by and available from AViTEQ permit an

adjustment of the vibration width and thus of the conveyance rate from almost

0 to 100 %. The controllers are available in several housing versions:

version in housing (IP 55): vibration width control and mains switch are

installed on the front side of the housing.

open version (IP 00 for SU... or IP 20 for SC...): vibration width control and

switch are included separately.

Operation without controller and connection to incorrect mains voltage/mains fre-

quency damage the drive. Make sure that the connection values are correct and

compare them with the device’s type labels!

4.2.1 Description of functionality

Three series of controllers with various characteristics are available:

l the modern electronic controller of type SU... with radio interference suppres-

sion according to level N and soft start

ATTENTION!

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

Pas de commentaire

AEG KF 31xx Manuel de service Page 31