AEG KF 31xx Manuel de service télécharger pdf (Page 22)

Installation of the Small Conveyor Drive – Installation of the working unit

3–2

For correct alignment of the vibration system, it is best to inform AViTEQ

Vibrationstechnik GmbH, Frankfurt, about the actual working weight (not

including transported goods) when ordering the small conveyor drive!

It is possible to run longer transport systems (channel or rail) with several succes-

sive small conveyor drives. Ask AViTEQ about it!

3.1.2 Before installation

Put the small conveyor drive onto a solid and flat surface!

Have the mounting bolts for the working unit ready. Ensure that the bolts

have the correct length!

The controller must be separated from the mains if it has already been con-

nected to the small conveyor drive.

If there is insufficient support, the conveyor may fall off the assembly table and,

under the worst circumstances, may cause injuries. You should therefore ensure a

safe support!

Follow the installation steps in the following diagram (see Figure 3.5 on page

5) and read the associated explanations. This procedure will simplify the

assembly for you!

3.1.3 Notes regarding the attachment with bolts

Install the working unit by bolting it onto the small conveyor drive. Depending

on the version of the small conveyor drive, the bolts are inserted from above,

from the side, or from the face (positions no. 7, 8, and 9 in the installation dia-

gram, Figure 3.5). The picture shows examples of KF drives for working unit

attachment from above and from the side:

F Only use the bolts specified for the individual small conveyor drives in

table 3.2!

F Please observe the tightening torques speficied in table 3.3!

F Ensure that the attachment bolts are not too long! If they are, the working unit

may not be able to be attached, or the bolts ends pointing to the inside

restrict the movement of the upper part of the small conveyor drive.

F Do not drill holes into the bottom of the channel! Protruding bolt heads

obstruct the product flow. Rather, you should use joints on the side or under-

side of the working unit for the attachment to the small conveyor drive.

NOTE

DANGER!

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 53 54

Pas de commentaire

AEG KF 31xx Manuel de service Page 22