AEG HK312000MB Manuel d'utilisateur télécharger pdf (Page 10)

• Make sure that there is an access to

the mains plug after installation.

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or

a multiple connection (risk of fire).

Check that the ground connection is

in conformity with the standard and

regulations force.

• The power cable must be placed in

such a way that it does not touch any

hot part.

• Connect the appliance to the mains

with a device that lets to disconnect

the appliance from the mains at all

poles with a contact opening width of

minimum 3 mm, eg. automatic line

protecting cut-out, earth leakage trips

or fuse.

• None of a parts of the connection ca-

ble can not get a temperature 90 °C.

The blue neutral cable must be con-

nected to the terminal block label with

"N". The brown (or black) phase cable

(fitted in the terminal block contact

marked with "L") must always be con-

nected to the live phase.

8.3 Replacement of the

connection cable

To replace the connection cable use on-

ly H05V2V2-F T90 or equivalent type.

Make sure that the cable section is appli-

cable to the voltage and the working

temperature. The yellow/green earth

wire must be approximately 2 cm longer

than the brown (or black) phase wire.

8.4 Assembly

40-50 mm

55 mm

30 mm

min. 650 mm

490 mm

270 mm

1.

Put the sealing gasket around the

edge of cut out.

2.

Install the appliance in cut out and

push it down until it touch the kitch-

en top surface. Then remove the re-

maining gasket.

10

www.aeg.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire