AEG FM4360GAN Manuel d'utilisateur télécharger pdf (Page 23)

Silicone

Mounting:

When mounting several hobs together you must use a reinforcement beam

between each hob as well as the silicone supplied with the hobs (see fig.)

1. Cut a hole of the calculated size in the table top

2. Place the individual hobs upside down on a mat. Take care that the top side is

not scratched.

3. Mount the clamping fittings in the holes in the side of the base panels (see

fig.)

4. Place the first hob in the hole.

5. Apply silicone to the two corners joining the next hob (see fig.)

Use only the silicone supplied with the hobs as this is intended to tolerate the

high temperatures of the appliance.

6. Push a reinforcement beam up against the hob. Apply silicone on the rein-

forcement beam (see fig.)

7. Tighten the clamping fittings to the table top using a screwdriver.

8. Repeat the process for the other hobs.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Pas de commentaire

AEG FM4360GAN Manuel d'utilisateur Page 23