AEG 6530K-MNAC1 Manuel d'utilisateur télécharger pdf (Page 30)

Installing and connecting up

• All cut surfaces are to be sealed with a suitable sealant for protection

against moisture.

• On tiled work surfaces, the joints in the area where the hob sits on

the surface must be completely filled with grout.

• On natural, artificial stone, or ceramic tops, the snap action springs

must be bonded in place.

• Ensure that the seal is correctly seated in the frame and that it is sea-

ted against the work surface without leaving any gaps. Additional

silicon sealant must not be applied, this will make removal more diffi-

cult in the event of the need for service.

• To remove the hob, it must be pressed out from below.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35

Pas de commentaire

AEG 6530K-MNAC1 Manuel d'utilisateur Page 30