Aeg COMPACT READER ARE I2 Manuel d'utilisateur télécharger pdf (Page 17)

Manual

Page 17 / 33- Revision 01

ARE I2 / RS 232 – Installation Guide

AEG

Identifikationssysteme GmbH

Söflinger Straße 100

D-89077 Ulm

Tel. ++49(0)731-933-1340/1877

Fax ++49(0)731-933-1855

Input format: CID <SP> parameter <CR>

Parameter:

Value

Function

0 no filter function , (default value)

1 suppression of repeatedly read IDs

Please note: The CID parameter is only active, if the GT-Command is applied or the reader is

in the Continuos Reading Mode. In the MD 2 anyway a <CR> is sent to the master.

6.4 CN – Suppression of No Reads

Through the setting CN=1 all NoRead results are suppressed on the serial interface..

Input format: CN <SP> parameter <CR>

Parameter:

Value

Function

0 issue NoReads on serial interface; (default value)

1 suppress NoReads on interface

Output (example): 0 <CR>

Please note: The CN parameter is only active, if the GT-Command is applied or the reader is in

the Continuos Reading Mode. In the MD 2 any way a <CR> is sent to the master.

6.5 NID- Failure Protection

NID specifies the number of identical transponder numbers, which have to appear for the

result “successful reading“ within a reading cycle. In the setting NID = 1, two successive

readings have to show the same transponder number.

Input format: NID <SP> parameter <CR>

Parameter:

Value

Function

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 32 33

Pas de commentaire

Aeg COMPACT READER ARE I2 Manuel d'utilisateur Page 17