AEG LFX7G7224FB Manuel d'utilisateur

USER MANUALEN User ManualWashing MachineLFX7G7224FB

5. Connect the water inlet hose to the coldwater tap with 3/4 thread.WARNING!Make sure that there are noleaks from the couplings.Use the hose supplied

LTo a wall-pipeDirectly to a built-in drain pipe in the roomwall and tighten it with the supplied cable tie L.You can extend the drain hose to maximum

Before proceeding with appliance building in,bring it near the recess and preposition theinlet hose, the drain hose and the mainscable.WARNING!Make su

MNOIf the cupboard door has to be opened fromleft to right, invert the position of the hingesupports M with the magnetic plate N andlower plate O.MNOM

AHingesTo mount the hinges it is necessary to drilltwo holes (dia. 35 mm, depth 12.5 - 14 mmdepending on the depth of cupboard door)on the inner side

4. PRODUCT DESCRIPTION4.1 Appliance overview1011 121321 35476891Hinge supports2Detergent dispenser3Control panel4Magnetic plate5Door handle6Rating pla

The permanent options areset by holding pressed therelative button for at least 3seconds.1Programme dial2Display3Delay Start touch button4Time Save to

Add garments indicator. it lights at the beginning of the washingphase, when it is still possible to pause the appliance and addmore laundry.Child saf

phase uses more water for somewashing programmes• Night . The related indicatorcomes on.The intermediate and the finalspinning phases are suppressed

When the programme stops the displayshows , the indicator goes offand the indicator is steady on. Thedrum performs smooth movements forabout 30 m

CONTENTS1. SAFETY INFORMATION...32. SAFETY INSTRUCTIONS...

6.14 Start/Pause Touch the Start/Pause button to start,pause the appliance or interrupt arunning programme.7. PROGRAMMES7.1 Programme ChartProgrammeDe

ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedMaxi-mumloadProgramme description(Type of load and soil level)Steam programme Steam pr

ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedMaxi-mumloadProgramme description(Type of load and soil level)Sport30 °C40 °C - Cold12

ProgrammeDefault tem-peratureTemperaturerangeReferencespin speedMaxi-mumloadProgramme description(Type of load and soil level)Denim30 °C40 °C - Cold80

Programme Spin Rinse HoldNospin Night Prewash1) 2) Soft Plus Plus Steam2) Delay Start Time SaveSteam Spin/Drain 3)

8. SETTINGS8.1 Acoustic signalsThis appliance has different acousticsignals, that operate when:• You activate the appliance (specialshort tune).• You

CAUTION!Make sure that no laundrygets caught between theseal and the door to avoidrisk of water leakage anddamage to the laundry.Washing heavily oiled

• Do not exceed to liquiddetergent dose indicated on theflap.• Do not set the prewash phase.• Do not set the delay startfunction.5. Measure out the de

10.8 The ProSense Systemload detectionAfter touching the Start/Pause button:1. The ProSense System startsestimating the weight of the load tocalcula

2. Remove the laundry from theappliance.3. Make sure that the drum is empty.4. Keep the door and the detergentdispenser slightly ajar to preventmildew

1. SAFETY INFORMATIONBefore the installation and use of the appliance,carefully read the supplied instructions. Themanufacturer is not responsible f

• Be careful with curtains. Remove thehooks and put the curtains in awashing bag or pillowcase.• Do not wash laundry without hems orwith cuts.• Use a

12. CARE AND CLEANINGWARNING!Refer to Safety chapters.12.1 External cleaningClean the appliance with mild soap andwarm water only. Fully dry all thesu

1. Remove all laundry from the drum.2. Run a Cottons programme with thehighest temperature.3. Add a small quantity of powderdetergent into the empty d

Regularly check the drainpump filter and make surethat it is clean.Clean the drain pump if:• The appliance does not drain thewater.• The drum does not

180˚3. Turn the filter 180 degrees in anti-clockwisedirection to open it, without removing. Let thewater flow out.4. When the bowl is full of water, t

219. Put the filter back into the special guides byturning it clockwise. Make sure that youtighten the filter correctly to prevent leakages.1210. Clos

45°20°12.9 Emergency drainIf the appliance cannot drain the water,carry out the same procedure, describedin 'Cleaning the drain pump' paragr

• - No communication between electronic elements of the appliance. Switch itoff and switch on again. The programme was not finished properly or the a

Problem Possible solutionThe appliance does notfill with water properly.• Make sure that the water tap is open.• Make sure that the pressure of the wa

Problem Possible solutionThe appliance makes anunusual noise and vi-brates.• Make sure the levelling of the appliance is correct. Refer to"Instal

• The appliance must be connected to the water mainsusing the new supplied hose sets, or other new hosesets supplied by the Authorised Service Centre.

2. Disconnect the mains plug from themains socket.3. Pull the emergency unlock triggerdownward once. Pull it once again,keep it tensed and, in the mea

Programmes Load(kg)Energy con-sumption(kWh)Water con-sumption (li-tre)Approxi-mate pro-gramme du-ration (mi-nutes)Cottons60°C7 1.20 79 190Cottons Eco6

Energy Efficiency Class A+++Spin Speed Maximum spin speed 1151 rpm1) Connect the water inlet hose to a water tap with a 3/4'' thread.16. ENV

ENGLISH 43

www.aeg.com/shop157024830-A-412018

• Always use a correctly installedshockproof socket.• Make sure that the parameters on therating plate are compatible with theelectrical ratings of th

3.1 Be prepared forinstallationIt is recommended thatinstallation is carried out bytwo persons.3.2 The appliance is equippedwith ...x1 x2x1Ex2x1 x1x2x

123. Remove the polystyrene protectionfrom the bottom.124. Return the appliance in verticalposition and remove the socketpolystyrene protection.5. Rem

FG7. Close the holes with the plastic capsyou find in the user manual bag. Put thesmallest cap F in upper hole and the twobigger caps G in lower holes

3.5 Hose and cable connection1100 mm 1450 mm960 mm1230 mm900 mm1360 mmmax 1000 mmmin. 600 mmmax 1000 mmmin. 600 mmThe inlet hose1. Remove the