Aeg L61470BI Manuel d'utilisateur télécharger pdf (Page 24)

Problem Possible cause Possible solution

You cannot open

the appliance

door.

The washing pro-

gramme is in operation.

Let the washing programme

end.

There is water in the

drum.

Set the drain or the spin pro-

gramme.

The appliance

makes an unusual

noise.

Incorrect level of the ap-

pliance.

Adjust the level of the appli-

ance. Refer to 'Installation'.

You did not remove the

packaging and/or the

transit bolts.

Remove the packaging and/or

the transit bolts. Refer to 'Instal-

lation'.

The load is very small. Add more laundry in the drum.

The appliance fills

with water and

drain immediately.

The end of the drain

hose is too low.

Make sure that the drain hose is

in the correct position.

The washing re-

sults are not satis-

factory.

The detergent you used

was not sufficient or cor-

rect.

Increase the detergent quantity

or use a different one.

You did not remove the

stubborn stains before

you wash the laundry.

Use special products to remove

the stubborn stains.

Incorrect temperature

was set.

Make sure that you set the cor-

rect temperature.

Too much laundry load. Decrease the laundry load.

After the check, activate the appliance.

The programme continues from the

point of interruption.

If the problem occurs again, contact the

service centre.

If the display shows other alarm codes,

contact the service centre.

13. INSTALLATION

13.1 Fixing plate kit

(405517114)

Available from your authorized dealer.

If you install the appliance on a plinth,

secure the appliance in the fixing plates.

Follow the instructions supplied with the

kit.

24

www.aeg.com

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire