AEG HG694340XB Manuel d'utilisateur télécharger pdf (Page 12)

8. INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down

the information bellow from the rating

plate. The rating plate is on the bottom

of the hob.

Model .......................................

PNC .........................................

Serial number ...........................

8.2 Gas Connection

WARNING!

The following instructions

about installation,

connection and

maintenance must be

carried out by qualified

personnel in compliance

with standards and local

regulations in force.

Choose fixed connections or use a

flexible pipe in stainless steel in

compliance with the regulation in force.

If you use flexible metallic pipes, be

careful they do not come in touch with

mobile parts or they are not squeezed.

Also be careful when the hob is put

together with an oven.

Make sure that the gas

supply pressure of the

appliance obeys the

recommended values. The

adjustable connection is

fixed to the comprehensive

ramp by means of a

threaded nut G 1/2". Screw

the parts without force,

adjust the connection in the

necessary direction and

tighten everything.

A B C

A. End of shaft with nut

B. Washer

C. Elbow (if needed)

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

"Flexible" connection with mechanical

end:

• Natural gas: connection carry out

with a flexible pipe with mechanical

end which is screwed directly on the

elbow finishing the slope of the

appliance.

• Butane/Propane: use a flexible tube,

equipped with it's collars if it is worth

visiting over all it's length and if the

appliance runs only on butane. If the

appliance runs on Propane, use a

flexible pipe with suitable metal end.

Flexible nonmetal pipes connection:

If it is possible to easily control the

connection in its full area, you can use a

flexible pipe. Tightly attach the flexible

pipe by clamps.

Liquid gas

Use the rubber pipe holder for liquid

gas. Always engage the gasket. Then

continue with the gas connection.

The flexible pipe is prepared for apply

when:

• it can not get hot more than room

temperature, higher than 30°C;

• it is no longer than 1500 mm;

• it shows no throttles;

• it is not subject to traction or torsion;

• it does not get in touch with cutting

edges or corners;

• it can be easily examined in order to

make sure its condition.

The control of preservation of the flexible

pipe consists in checking that:

www.aeg.com

12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire