AEG HG694340XB Manuel d'utilisateur télécharger pdf (Page 12)

The connection should be suitable for

connecting to R 1/2 (1/2 BSP male

thread).

When the final connection has been

made, it is essential that a thorough leak

test is carried out on the hob and instal-

lation.

Make sure that the main connection

pipe does not exert any strain on the

hob.

If you use flexible metal pipes make sure

that they agree to ISO 10380 and ISO

10807 standards. Be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

It is important to install the elbow

correctly, with the shoulder on

the end of the thread, fitted to

the hob connecting pipe.

Failure to ensure the correct as-

sembly will cause leakage of gas.

Make sure that the gas supply

pressure of the appliance obeys

the recommended values.

Rigid connection:

Carry out connection by using metal rig-

id pipes (copper with mechanical end).

8.3 Injectors replacement

1.

Remove the pan supports.

2.

Remove the caps and crowns of the

burner.

3.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the

type of gas you use (see table in

"Technical Information" chapter).

4.

Assemble the parts, follow the same

procedure backwards.

5.

Replace the rating plate (it is near

the gas supply pipe) with the one for

the new type of gas supply. You can

find this plate in the package sup-

plied with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.4 Adjustment of minimum

level

To adjust the minimum level of the burn-

ers:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the

by-pass screw position.

A

A)

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the

adjustment screw in.

• If you change from liquid gas to natu-

ral gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn.

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.5 Electrical connection

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the cabi-

net, in order to avoid any contact with

the equipment beneath the cooktop.

• Make sure that there is access to the

mains plug after the installation.

12

www.aeg.com

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire