AEG 68001K Manuel de service télécharger pdf (Page 24)

19 599 519 523 EN

DGS-TDS

21.04.08

5.3.2 Error appliance can not be operated, display indicates "0"

This error has been disappeared after a reset.

For that there were 2 fault reasons in the hardware and software, this was removed by SW Vers. 4.2

from Dec. 2004.

6 Frontline self-sufficient hobs

6.1 Special references disassembly/assembly in case of a service:

1. Disassemble appliance

Î Remove tension clips

2. Open appliance

Î Attention! Before disassembling the glass draw off the connecting line between the user interface at the glass and

induction.

3. Replacement of display units

Î By means of a coin loosen plastic carriers by pressing and turning (29)

Î Shift back the plastic carrier until the front edge can be seen.

Î Lay plastic carrier to the bottom side

Î Remove locking bars like (30)

Î Draw off flat band cable

Î Replace electronic board

Î Assemble in the same way. Pay absolute attention to the correct putting and locking of the

band cable.

User interface and connection of two electronics at the glass ceramic (58 and 72 cm appliances)

(33) clamp bradings into the locking clips of the right carrier.

(29) (33)

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 47 48

Pas de commentaire

AEG 68001K Manuel de service Page 24