AEG FSE62700P Manuel d'utilisateur télécharger pdf (Page 42)

11.4 Internal cleaning

• Carefully clean the appliance,

including the rubber gasket of the

door, with a soft damp cloth.

• If you use short duration programmes

regularly, these can leave deposits of

grease and limescale inside the

appliance. To prevent this, we

recommend running long duration

programmes at least twice a month.

• To maintain the performance of your

appliance at its best, we recommend

using a specific cleaning product for

dishwashers (at least once a month).

Follow carefully the instructions on

the packaging of the product.

12. TROUBLESHOOTING

If the appliance does not start or it stops

during operation, first check if you can

solve the problem by yourself with the

help of the information in the table or

contact an Authorised Service Centre.

WARNING!

Repairs not properly done

may result in serious risk to

the safety of the user. Any

repairs must be performed

by qualified personnel.

With some problems, the display

shows an alarm code.

The majority of problems that can

occur can be solved without the need

to contact an Authorised Service

Centre.

Problem and alarm code Possible cause and solution

You cannot activate the ap-

pliance.

• Make sure that the mains plug is connected to the

mains socket.

• Make sure that there is no damaged fuse in the fuse

box.

The program does not start. • Make sure that the appliance door is closed.

• If the delay start is set, cancel the setting or wait for the

end of the countdown.

• The appliance has started the procedure to recharge

the resin inside the water softener. The duration of the

procedure is approximately 5 minutes.

The appliance does not fill

with water.

The display shows or

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not

too low. For this information, contact your local water

authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clogged.

• Make sure that the inlet hose has no kinks or bends.

The appliance does not

drain the water.

The display shows .

• Make sure that the sink spigot is not clogged.

• Make sure that the filter in the outlet hose is not clog-

ged.

• Make sure that the interior filter system is not clogged.

• Make sure that the drain hose has no kinks or bends.

www.aeg.com42

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

AEG FSE62700P Manuel d'utilisateur Page 42

Commentaires sur ces manuels

Produits connexes et manuels pour Lave-vaisselle AEG FSE62700P