AEG L98699FL2 Manuel d'utilisateur

L 98699 FL2EN WASHING MACHINE USER MANUAL

•The time of delay– When you set the delayed start the time of the programme end in-creases by steps of 30 minutes till 10 hours and by steps of oneho

Rinse hold1) Only available for Spin/Drain programme.JThe default temperature of the programme.Cold washSTOOM BUTTON 4Touch button 4 to set the steam

The appliance soaks the laundry at 30°Cfor about half an hour before to wash.SPIN BUTTON 11Touch button 11 to:• Decrease the maximum speed of thespin

WASHING PROGRAMMESProgramme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsKatoen 95° - Cold White and col-oured cottonwith heavy

Programme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsFijne Was 40° - ColdRinsesShort spinDelicate fabricsas acrylics, vis-cose

Programme Temperature Type of loadWeight of loadProgrammedescriptionFunctionsOutdoor 40° - Cold Waterproof,sports and out-door clothing.Do not use any

10) Set this programme to have a good washing results and decrease the energyconsumption. The time of the washing programme is extended.STEAM PROGRAMM

CONSUMPTION VALUESThe data of this table are approximate. Different causes can change the data:the quantity and type of laundry, the water and ambient

CLOCK SETTINGAfter you set the language, the displaytells to set the clock:• The hour digits flash.• Turn the programme knob to changethe hour.•Touch

If you put more laundry than themaximum load, the display tellsthat you put more than the maxi-mum load.You can wash your laundry but theenergy and wa

CONTENTS4 SAFETY INFORMATION5 TECHNICAL INFORMATION6 PRODUCT DESCRIPTION7 INTERIOR ACCESSORIES8 CONTROL PANEL13 WASHING PROGRAMMES17 CONSUMPTION VALUE

This is the maximum level for the quantity of liquid additives.The compartment for the stain remover.Put the product in the compartment and set the st

5.Measure out the detergent and thefabric conditioner.6.Carefully close the detergent dis-penser. Make sure that the flap doesnot cause a blockage whe

If the temperature and the level ofthe water is too high, the doorlock symbol stays on. You cannotopen the door. If necessary, dothe following procedu

HELPFUL HINTS AND TIPSTHE LAUNDRY LOAD• Divide the laundry in: white, coloured,synthetics, delicates and wool.• Obey the washing instructions that are

Level TypeWater hardness°dH °T.H. mmol/l Clarke2 medium 8-14 16-25 1.6-2.5 10-163 hard 15-21 26-37 2.6-3.7 17-254 very hard > 21 > 37 >3.7 &g

CARE AND CLEANINGWARNING!Disconnect the appliance from the mainssupply before you clean it.DESCALINGThe water we use contains limescale. If itbecomes

DETERGENT DISPENSERTo clean the dispenser:121.Press the lever.2.Pull the dispenser out.3.Remove the top part of the liquid ad-ditive compartment.4.Cle

To clean the drain pump:1.Open the drain pump door.2.Pull the flap out to remove it.3.Put a container below the recess ofthe drain pump to collect the

129.Clean the filter under the water tapand put it back in the pump into thespecial guides.10.Make sure that you tighten correctlythe filter to preven

When you drain the water with the emer-gency drain procedure, you must activateagain the drain system:1.Put 2 litres of water in the main washcompartm

FOR PERFECT RESULTSThank you for choosing this AEG product. We have created it to give youimpeccable performance for many years, with innovative techn

TROUBLESHOOTINGThe start of the appliance does not occuror it stops during operation.Try to find a solution to the problem be-fore you contact the ser

PROBLEM WITHOUT ALARM MESSAGEProblem Possible cause Possible solutionThe appliancedoes not drainthe water.A washing programmewithout the drain phaseis

Problem Possible cause Possible solution You did not remove thepackaging and/or thetransit bolts.Remove the packaging and/orthe transit bolts. Refer

INSTALLATIONFIXING PLATE KIT (405517114)Available from your authorized dealer.If you install the appliance on a plinth, se-cure the appliance in the f

5.Open the door. Remove the polystyr-ene piece from the door seal and allthe items from the drum.6.Put one of the polystyrene packagingelements on the

AB9.Make sure to identify the differentsizes and the positions of the soundbarriers. Refer to the illustration:A (FRONT) = Front of the applianceB (BA

13.Turn the three bolts with the key sup-plied with the appliance. Pull out theplastic spacers.14.Put the plastic caps in the holes. Youcan find these

• The appliance must be level and stable.CAUTION!Do not put cardboard, wood orequivalent materials below theappliance feet to adjust the level.THE INL

Water-stop deviceAThe inlet hose has a water stop device.This device prevents water leaks in thehose because of its natural ageing. Thered sector in t

Without the plastic hose guide.• To a sink spigot.Refer to the illustration. Put the drainhose in the spigot and tighten it with aclip. Make sure that

SAFETY INFORMATIONBefore the installation and use, read thismanual carefully:• For your safety and the safety of yourproperty• To help the environmen

www.aeg.com/shop 132924260-A-102012

To replace the internal lamp, con-tact the service centre.Disconnect the mains plug fromthe mains socket before the re-placement of the internal lamp.

Level of protection against ingress of solid particlesand moisture ensured by the protective cover, exceptwhere the low voltage equipment has no prote

INTERIOR ACCESSORIES1 245 31SpannerTo remove the transit bolts.2Plastic capsTo close the holes on the rear side ofthe cabinet after the removal of the

CONTROL PANELGeheugen 1Geheugen 2StoomStart/PauzeStart-uitstelTijdBesparenExtraSpoelenVlekken/Voorw.TPMTemp.°C1 2 3678910111245Wol/ZijdeKatoenExtra St

DISPLAY 3ABCDEFGHIJAThe text bar:• Guides you in the use of the appliance.• Shows the programme status and phase.• Shows alarm messages. Refer to &apo